![]() ![]() Here is a nice picture someone got of the tower designs I brought to the 2014 Midwest Audio Fest: WTMW Center channel 3-way (configurable in vertical WTMW cabinet or TMWW tower form) ![]() I’ll update and post links to each of the respective designs below when I get them written up. Visually they match well, the DS and SD drivers sharing the same frame style and cone material and all the drivers looked to perform well within their respective bandwidths. I settled on the Dayton ND28F-6 for the tweeter, the Dayton DS135-8 as the midrange and two Dayton SD215-88A’s as woofers. Finally I wanted the midrange/midbass able to be used in a compact two way surround with decent power handling and extension in a small ported enclosure. ![]() I also wanted the drivers to match if possible and give a nominal 8 ohm load so it would be safe for even the most anemic AVR or those super cautious users who just don’t want to risk driver a lower impedance speaker. I wanted to use drivers that would offer very good performance yet keep the cost of the design in reach of those looking not looking to spend an arm and a leg. These designs came about from my interest in building a conventional 3-way design (which there seem to be a lack of kits for) and one which would allow for an ideal horizontal center channel use. Timbre matched family of Hi-Fi/HT speakers all based on the same midwoofer (Dayton DS135-8) and tweeter (ND28F-8).
0 Comments
Leave a Reply. |